Browsing this Thread:
1 Anonymous Users
Re: Advice for dealing with contractors, permitting and inspections
|
||||
---|---|---|---|---|
Home away from home
|
Are you knocking down a wall? If you do then I would say yes because you need support beams. If not, I would trust the person doing the work. Spell everything out in the agreement. And pay in thirds. One third up front, one third with half done and the last payment when finished. If this room is near a bedroom make sure your contractor puts in soundproofing in.
Posted on: 2021/3/31 1:35
|
|||
|
Advice for dealing with contractors, permitting and inspections
|
||||
---|---|---|---|---|
Not too shy to talk
|
I'm looking for any tips/advice on doing a small renovation project properly (everyone licensed, getting permits for everything). I'm getting so much conflicting information (not to mention all over the place bids) from different contractors.
The project is to run water/electrical to a closet behind the kitchen in order to install a washer and dryer. I am not sure if I need an architect as I have been told yes from one contractor, but the other contractors have not mentioned using an architect at all. I was also told that the building as it is is not zoned for a "laundry room" and that the architect would need to apply for that change. I was not aware of this process and I'm not sure if that is the same as getting the permits or a whole separate thing? If anyone has any advice or experience with this process I would appreciate any info. Thanks!
Posted on: 2021/3/31 0:11
|
|||
|